Aşağıda Jeanneau Proboards'dan alınma iki yazı var.
Bunlar yazılarda Cristec redresörlerin BOOST modunda aküleri kaynattığından ve yüzeylerinin çok ısındığından bahsediyor.
Sizde de BOOST modu aktif olabilir mi ?
TANER
Mar 31, 2019 at 12:21pmQuotePost OptionsPost by Mike on Mar 31, 2019 at 12:21pm
Hi,
When we returned to our boat this year we switched on the battery charger on the main switch board, within a few hours a bad smell developed, we discovered two of our five AGM's had cooked.They were isolated by an electrician, which left us with three connected. We have monitored our system and found the outer case of our Cristec CPS3 charger to be getting hot. My question is "can any one tell me how hot/warm theirs is getting ?" Ours when on boost ours gets very hot, switch off SW1 and the case cools to warm.
Also it recommends in my manual to get the charger inspected every 5 years by a Cristec approved engineer. Has any one had this done? if so, were there any problems?
Mar 31, 2019 at 11:34pmQuotePost OptionsPost by rc sail on Mar 31, 2019 at 11:34pm
I share your frustration as my Cristec charger stayed in boost mode toasting 4 of my 7 batteries last summer. I did
discuss this and a posting in these pages previously. I had no trust for the Cristec charger after this episode and it was replaced. There have been other postings on this charger and a recommendation is to disable, turn off, the boost function
on the charger.
Gönderen